Rizzoli TE 60 Manuel D'utilisation page 54

External air entry
B C
Picture 8 - Rear sight of the stove and specifies for the
connection with the air intake.
2.9 PLINTH REGULATION
The plinth of TE 60 stove can be regulated in order
to match the space in which the stove is inserted.
It is possible to adjust the level of the stove by op-
erating on the levelling pins that can be regulated
in height. To regulate easily the pins, it is necessary
to remove the insert framed below the fire door:
to this it is necessary to open completely the fire
door, unscrew the two fixing screws, keep inclined
WARNING! Once the stove is placed, it is suggested to lift the pins of about 5 mm to
allow the correct air flow.
0-20 mm
Picture 9 – Regulation of the height of the stove with hex key through the levelling pins
Models
TE 60
A
H
Table 2 - Dimensions for the connection of the external
B
the insert of about 30°, close the fire door and re-
move softly the insert. Now, it is possible to reg-
ulate singularly each pin placed in the plinth near
the corners, so that the adjustment of the stove is
correct. For the regulation of the pins, use an hex
key n.6: once you have reached the desired height,
fix the locknut with a n.13 key (see picture 9). The
pins have an excursion of 20 mm.
N.6
N.13
52
A B C
160 98 440 180 95
air intake
H ø