Rizzoli TE 60 Manuel D'utilisation page 53

the air intake only when it is necessary for the
correct working of the stove, in order to warrant
a maximum depression of 4 Pa in the place of in-
stallation.
TE 60 stove can also be connected so that the
comburent air comes directly from outside. In this
way, for the stove it is not necessary another air
Picture 6 - Installation with air intake in the room of installation and installation with air intake directly
connected to the stove.
A
Picture 7 - Possible connections of the air intake of the stove. A = External air intake not connected
B = External air intake on the floor C = External air intake on the wall
To make the connection easier we suggest to make
the external air intake on the floor in correspon-
dence with the stove, or on the wall through the
rear part of the stove (see picture 2 and table 8).
For the connection, it is suggested to insert the
WARNING! Aspiring hoods or extracting air fans in the room may generate problems
to the device if there is not a suited air intake or in case of air intake sub-dimensioned.
intake in the room of installation. To make this it is
necessary to prepare a conduct connected direct-
ly with the external part of the house and make a
direct connection with the air intake of the stove.
The air intake of the stove is located in the low-
er part. For the connection, we suggest to use a
flexible pipe.
B
flexible pipe in the rear conduct in the lower part
of the stove, remove the frontal covering (see
paragraph 2.9) and fix the pipe to the air intake
operating frontally.
51
C