Installation - Rizzoli TE 60 Manuel D'utilisation

1.5 ACCESSORIES
Together with Rizzoli TE 60 stove you will find
some accessories that simplify the installation, the
• Instruction booklet
• Green booklet and certificate of warranty
for the stove
2

INSTALLATION

2.1 GENERAL NOTES
The stove must be installed by experienced peo-
ple according to the specific technical laws. In
particular it is important to pay attention to the
connection to an appropriate heating system and
to the chimney, which must be suited and dimen-
sioned according to the device. When placing the
stove, you must pay attention to prevent damages.
It is necessary to remove the cover of the tank to
prevent damages during the transport: to do this,
remove the 8 sustaining screws. Do not drag the
stove, move it always keeping it lifted from the
floor. Do not lift the stove by handles. To reassem-
bly the cover of the tank screw in the 8 screws
removed previously. If there is furniture near the
stove, be sure the minimum safety distances in
case of inflammable or sensible to high tempera-
2.2 CHIMNEY
Picture 2 - Components of the chimney. A= stove, B= conjunction, C= flue, D= chimney, E= reflow zone
maintenance and the daily use of the device.
• Ash drawer
• Glove
• Scraper
tures materials according to the technical data (see
paragraph 6.4). In case of floor made of inflam-
mable materials it is necessary to put a fire-proof
protection on the floor in front of the fire door.
The protection must extend for a minimum of 80
cm in front and for a minimum of 30 cm sideways
over the fire door. In case of stove to be enclosed
near not heat sensible materials, it is necessary to
maintain a minimum distance of 1-2 mm to allow
the expansion of the materials when the tempera-
ture changes. The device must be placed on a floor
with enough load capacity. If the existing building
does not satisfy this condition, you must adopt dif-
ferent solutions (for example you can use a plate to
distribute the load).
D
E
C
B
A
48