Installation; General Notes - Rizzoli T Série Manuel D'utilisation

2 INSTALLATIONS
2.1

GENERAL NOTES

The thermostove must be installed by experienced
people according to the specific technical laws. In
particular it is important to pay attention to the
connection to a suitable heating system and to the
chimney, which must be suited and dimensioned
according to the device. When placing the stove,
you must pay attention to prevent damages. Do
2.2 PLACEMENT
In case of floor made of inflammable materials it
is necessary to put a fire-proof protection on the
floor in front of the fire door. The protection must
extend for a minimum of 80 cm in front and for
a minimum of 30 cm sideways over the fire door.
The device must be placed on a floor with enough
load capacity. If the existing building does not sat-
isfy this condition, you must adopt different solu-
tions (for example you can use a plate to distribute
Picture 3 – Fixing of the thermostove to the floor with silicon.
not drag the thermostove, move it always keeping
it lifted from the floor. Do not lift the thermostove
by handles. If there is furniture near the stove, be
sure the minimum safety distances in case of in-
flammable or sensible to high temperatures mate-
rials according to the technical data (see attached
technical sheet).
the load).
During the installation it must be considered the
stability of the device. If necessary, it is possible to
regulate the levelling pins to level the device (see
picture 3).
To improve the stability it is possible to fix the
thermostove to the floor with silicon or with two
screws placed in the rear part of the thermostove
itself.
74