Power Indicator - STAMOS S-PLASMA 55H Manuel D'utilisation

Heat protection
The thermal protection circuit takes action when the device exceeds the duty cycle.
This means stopping the machine.
Duty Cycle
The duty cycle is the percentage of the operating time (measured in minutes) of a
10-minute period in which the machine is used continuously in normal temperature
conditions. If the values of the duty cycle are exceeded, this will trigger the overheat
protection function, which stops the machine until it is cooled down to normal opera-
ting temperature. Repeated situations of exceeding the duty cycle values may lead to
serious damage of the machine.
EXPLANATION:
0.
On
On/off switch
Off
1.
CURRENT / Current controller:
main current is adjustable.
2.
Overload / Fault LED indicator:
The indicator lights in the following two situations:
a) If the machine has malfunctioned and can not be operated.
b) If the cutting device has exceeded the standard working time the
protection mode is initiated and the machine will stop functioning.
This means that the machine is now being cooled in order to be
able to restore temperature control again after the device has
overheated. Therefore the machine is stopped. During this process,
the red warning light on the front panel lights up. In this case it is not
necessary to remove the power plug from the socket. The ventilation
system may be left on in order to enhance the cooling of the machine.
When the red light goes dark, this means that the temperature is now
down to the normal level and the unit can be put back into operation.
72
EN DE
Rev. 02.03.2017
3.
POWER INDICATOR: This indicator lights up after turning the machine
on.
4.
LED - Display:
Displays the current amperage.
5.+6.
Ports for plasma torch:
The high energy density of the plasma arc enables a high cutting
speed with a warp-free cut quality. No special gas is required and
the possibility to use regular air pressure along with easy handling
of the unit are a guarantee of easy use in car bodies, containers,
steel construction, the HVAC industry as well as in installations and
plumbing.
7.
Grounding cable connection.
8.
GAS
GAS/air connection.
AIR
Rev. 02.03.2017
EN DE
73