Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
inSTallaTiOn
7.1 Safety precautions
DANGER!
hazard due to high pressure!
Interference with the system will result in an acute risk of injury.
•
Switch off the pressure before disconnecting lines and valves to which
the electronics are connected!
hazard due to electrical voltage!
Interference with the system will result in an acute risk of injury.
•
Before starting work, be sure to switch off the supply voltage and secure
it to prevent restarting!
•
Observe all applicable accident prevention and safety regulations for
electrical equipment!
WARNING!
unintentional operation or impermissible damage can lead to danger-
ous situations including physical injury.
•
Take suitable measures to prevent unintentional operation or inadmissible
damage!
hazardous situations can arise during installation work.
•
This work may only be carried out by specialist personnel using
appropriate tools!
•
Ensure that the process is restarted in a defined and controlled manner
after an interruption in the electrical or pneumatic power supply!
7.2 electrical connections
7.2.1 cable head version
The electrical connection of the Controller Type 8605 in cable head version
is made via a 4-pin terminal strip inside the device.
Cable
•
Diameter
•
Cross-section
Cable connections
20 - 8605
6 ... 8 mm
max. 0.75 mm
2
Cable gland or plug connector
M12, 4-pin
Publicité
Chapitres
Table des Matières
