Burkert 8605 KK Instructions De Service page 38

8.3.8 addr (address) - interfaces
Setting of the bus address when using the serial interface (0 to 1).
Illustration 8-12: Addr (Address) - Interfaces
8.3.9 SpOS (Safe position) - Setting
of the safety position
Input of the safety position (0.0 to 100.0 %) that is controlled with a se-
lected standard signal input of 4 to 20 mA and a drop below the 4 mA input
signal.
Illustration 8-13: SPOS (Safe position) - Setting of the safety posi-
tion
nOTe!
The standard signal 4 to 20 mA is the only one that permits a fault to be
detected when the input value drops below 4 mA. In this case it is possible
to define which current value is to be controlled (e. g. 50 %).
8 - 8605
Setting of the safety posi-