Burkert 8605 KK Instructions De Service page 27

8.3.1 inp (input) - Selection of the input signal
Enter the type of standard signal used under this menu item. You can select
between the following standard signals:
0 ... 5 V
0 ... 10 V
0 ... 20 mA
4 ... 20 mA
Illustration 8-3: InP (Input) - Selection of the input
signal
8.3.2 Out (Output) - Valve settings
In this menu the electronics are adjusted to
• the valve used and
• the fluidic conditions in the application.
Absolutely vital are
• the setting of the valve type in the sub-menu VALV and
• the setting of the working range of the coil current in the sub-menu AdJ.
nOTe!
The modifications of the PWM control frequencies possible in the sub-
menu VAdJ compared with the default values defined with the selection of
the valve type are only necessary in special applications.
8605 - 27