Connecting The Power Supply Cords - Yamaha DSP-AZ2 Mode D'emploi

Connecting the Power Supply Cords

AC IN
AC OUTLETS
SWITCHED
50W MAX. TOTAL
ECTOR
WER ON
REAR CENTER : 6ΩMIN./SPEAKER
CENTER : 4ΩMIN./SPEAKER
FRONT : 6ΩMIN./SPEAKER
REAR : 6ΩMIN./SPEAKER
MIN./SPEAKER
MAIN A OR B : 4ΩMIN./SPEAKER
MIN./SPEAKER
A + B 8ΩMIN./SPEAKER
:
MIN./SPEAKER
MIN./SPEAKER
MIN./SPEAKER
MIN./SPEAKER
(General and China models)
VOLTAGE SELECTOR
VOLTAGE
SELECTOR
AC IN
AC OUTLETS
SWITCHED
50W MAX. TOTAL
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR CENTER : 6ΩMIN./SPEAKER
CENTER : 4ΩMIN./SPEAKER
FRONT : 6ΩMIN./SPEAKER
6ΩMIN./SPEAKER
REAR :
:
REAR CENTER 8ΩMIN./SPEAKER
MAIN A OR B : 4ΩMIN./SPEAKER
CENTER : 8ΩMIN./SPEAKER
A + B 8ΩMIN./SPEAKER :
: 8ΩMIN./SPEAKER
FRONT
REAR : 8ΩMIN./SPEAKER
MAIN A OR B : 8ΩMIN./SPEAKER
:
A+B 16ΩMIN./SPEAKER
(General and China models)
I Connecting the AC power cord
To AC outlet
[Europe, General and China models]
Plug the power cord into the AC inlet when all
connections are complete, and then plug in this unit to the
wall outlet.
Caution
• Do not use other AC power cords than the one provided.
Otherwise it may result in causing fire or an electrical
shock.
[U.K. model]
Plug this unit into the wall outlet.
Plug in the other components connected to this unit to the
wall outlet.
I AC OUTLET(S) (SWITCHED)
Europe, General and China models ............. 2 OUTLETS
U.K. model ..................................................... 1 OUTLET
Use these outlets to connect the power cords from your
components to this unit. The power to the AC
OUTLET(S) is controlled by this unit's STANDBY/ON
(or SYSTEM POWER and STANDBY). These outlets
will supply power to any connected component whenever
this unit is turned on. The maximum power (total power
consumption of components) that can be connected to the
AC OUTLET(S) is:
Europe and U.K. models ........................................ 100 W
General and China models ....................................... 50 W
I VOLTAGE SELECTOR
(General and China models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE
plugging into the AC main supply. Voltages are 110/120/
220/240 V AC, 50/60 Hz.
CONNECTIONS
21