Hp Tone Ctrl (Headphone Tone Control); Center Geq (Center Graphic Equalizer); Input Rename - Yamaha DSP-AZ2 Mode D'emploi

4 HP TONE CTRL (headphone tone
control)
Use this feature to adjust the level of the bass and treble
when you use your headphones.
Control range (dB): –6 to +3 for both BASS and TRBL
(treble)
Initial setting: 0 dB for both BASS and TRBL (treble)
4 HP TONE CTRL
≥ B A S S
T R B L
-
5 CENTER GEQ (center graphic
equalizer)
Use this feature to adjust the built-in 5-band graphic
equalizer so that the center speaker tonal quality matches
that of the left and right main speakers. You can select the
100 Hz, 300 Hz, 1 kHz, 3 kHz, or 10 kHz frequencies.
Control range (dB): –6 to +6
Initial setting: 0 dB for 5-band
1
Press n to select a higher frequency and k
to select a lower frequency.
5 CENTER GEQ
≥ 1 0 0 H z
3 0 0 H z
1 k H z
3 k H z
1 0 k H z
-
2
Press –/+ to adjust the level of that
frequency.
5 CENTER GEQ
1 0 0 H z
≥ 3 0 0 H z
1 k H z
3 k H z
1 0 k H z
-
y
• You can monitor the center speaker sound while adjusting this
item by using the test tone. Press TEST before starting the
foregoing procedure. "TEST DOLBY SUR." or "TEST DSP"
appears on the video monitor, and the test tone starts
alternating among the speakers. Once you begin this procedure,
the test tone remains at the center speaker and you can hear
how the sound changes as you adjust the various frequency
levels. To stop the test tone, press TEST (see pages 25 to 27).
+
0 d B
+
0 d B
+
+ 3 d B

6 INPUT RENAME

Use this feature to change the name of the input which
appears on the OSD or the front panel display.
1
Press an input selector button to select the
input you want to change the name of.
6 INPUT RENAME
D V D ≥
- / + : P o s i t i o n
/ : C h a r a c t e r
2
Press –/+ to place the _ (under-bar) under
the space or the character you want to edit.
6 INPUT RENAME
D V D ≥
- / + : P o s i t i o n
/ : C h a r a c t e r
3
Press k / n to select the character you want
to use and –/+ to move to the next one.
• Press n to change the character in the following
order, or press k to go in the reverse order.
A to Z, a space, 0 to 9, a space, a to z, a space, #,
*, +, and so on.
• Follow the foregoing procedure to rename other
inputs.
6 INPUT RENAME
D V D ≥
- / + : P o s i t i o n
/ : C h a r a c t e r
Note
• You can use up to 8 characters to rename the inputs.
4
Press + repeatedly to exit from INPUT
RENAME.
SET MENU
D V D
D V D
D V D 1
61