Connecting The Power Cable; Turning On/Off The Unit; Other Functions; Turning Off The Unit Automatically (Auto-Standby Function) - Yamaha MX-A5000 Mode D'emploi

Connecting the power cable

After all the connections and switch operations are complete, connect the supplied
power cable to the unit and then to an AC wall outlet.
The unit (rear)
CTOR CH. SELECTOR CH. SELECTOR
H.4 CH.2 CH.3 CH.5 CH.6
L CH.3 L CH.6 L
BAL. UNBAL. BAL. UNBAL. BAL. UNBAL.
AC IN
To an AC wall outlet

Turning on/off the unit

Press z (power) to turn on/off the unit.
When the unit is turned on, the power indicator lights up.
The unit (front)
z (power)
• When an external device is connected to the TRIGGER IN jack, the unit is set to standby mode after
z (power) is pressed. If you turn on the external device, the unit automatically turns on by the trigger
function (p.9).
8

Other functions

En
CH.4
CH.3
CH.2
B
CH.2
A
Other functions
Turning off the unit automatically
(auto-standby function)
The unit will automatically go into standby mode 8 hours after the unit is turned on.
To disable the auto-standby function, set the AUTO POWER STANDBY switch to "OFF".
• The auto-standby function works even if playback is ongoing.
• When the system control cable is connected to the TRIGGER IN jack, the auto-standby function does not
work even if it is enabled.

Dimming the power indicator

You can dim the power indicator on the front panel of the unit.
• When an external device is connected to the TRIGGER IN jack, turn on it before performing the following
procedure.
a If the unit is turned on, press z (power) to turn off it.
b Press z (power) three times within 3 seconds.
The power indicator dims.
• To cancel the dimmer, perform the procedure again.
• If the power cable is unplugged, the dimmer will be canceled.