Yamaha F6AMH Manuel D'entretien page 408

UPPER CASE
INSTALLING THE LOWER MOUNT
1. Install:
Lower front mount rubber


NOTE:
Set the "UP" mark upward.
2. Install:
Lower mount rubber housing


NOTE:
Install the mounting bolt while


confirming the identifying "V" mark on
its head.
Pass the stop switch lead wire together


with the throttle wire through the
corrugated tube, pass under the throttle
wire, and then insert in the grommet of
the bottom cowling.
Tighten 2 front bolts 1 to the specified


torque, then tighten 2 rear bolts 2 to the
specified torque.
Finally, check that all 4 bolts are tightened
to the specified torque.
7-22