Trotec T500 Manuel D'utilisation page 47

measurements. You should therefore check regularly that
the cap nuts are tight and retighten them by hand if
necessary. To avoid damage to the device, do not use any
aids such as pliers to do this.
• The electrode protector must always be pushed onto the
measuring device both before and after measurements,
otherwise there is a danger of injury due to the open
measuring spikes in the case of careless handling and during
the measurement.
•
Operating manual – English
Never pull the measuring device out of
the measured material with force; loosen
it with a careful right to left movement.
The use of force can lead to bending
or breakage of the measuring spikes
as a result of excessive bending
moments!
B - 14