Filling The Water Tank - Cleanmaxx JC-236 Mode D'emploi

Window cleaning adapter

Filling the water tank

ATTENTION!
❐ Always turn off the device before you fi ll the water tank.
❐ Never add cleaners or other additives to the water tank. They may irreparably dam-
age the device and as such, the safe operation of the device can no longer be as-
sured. Use cold, distilled water or cold tap water to fi ll the device.
❐ Do not overfi ll the water tank. Do not fi ll the water tank past the MAX mark.
❐ Never operate the device without water. After prolonged use, be sure to refi ll the
water tank in time.
1. Open the water tank (10).
2. Mount the cushion cleaning adapter on the extension
hose. It must audibly lock into place. To remove it, hold the
release button down and pull the cushion cleaning adapter
off of the extension hose.
3. Slip the cushion cleaning cloth over the cushion cleaning
adapter and pull the draw string tight.
1. Insert the extension hose in the steam vent on the main
unit. It must audibly lock into place. If you would like to re-
move the hose again, hold the release button on the main
unit down and pull the hose out of the main unit.
2. Mount the window cleaning adapter on the extension
hose. It must audibly lock into place. To remove it, hold the
release button down and pull the window cleaning adapter
back off of the extension hose.
3. You can use either a smooth or structured cleaning cloth
for the window cleaning adapter.
4. Attach the smooth cleaning cloth by pulling the cloth over
the bottom part of the window cleaning adapter and hook-
ing it in place under the rubber squeegee lip.
5. Attach the structured cleaning cloth by pulling the cloth
over the bottom part of the window cleaning adapter and
hooking it in place under the rubber squeegee lip. Then
pull the draw string tight.
29