Filling The Water Tank - Cleanmaxx 08337 Mode D'emploi

• If you would like to use one of the other enclosed nozzles, it must fi rst be attached to
the nozzle adapter (G):
• The nozzle adapter will be attached to the main unit in the exact same manner as the
cleaning head: Insert it in the steam nozzle until the catch audibly locks into place.
• To remove the nozzle adapter, depress the catch and pull the adapter out at the
same time.
Attaching the fl oor pad and carpet glider

Filling the water tank

NOTE!
■ Do not overfi ll the water tank!
■ Only ever pour tap water and not distilled water or other liquids into the water tank
to prevent any damage to the device!
■ Never pour any cleaning agent or additives into the water tank. This might damage
the device.
If the power LEDs (12) are blinking red, the water tank (7) is empty and has to be fi lled.
08337_DE-EN-FR-NL_A5_V4.indb 23 08337_DE-EN-FR-NL_A5_V4.indb 23
23
To remove the cleaning head, depress the catch and pull the
cleaning head out at the same time.
• An arrow is embossed on the end piece of the nozzle
and the nozzle adapter. Connect the two parts so that the
arrows are pointing towards one another and then turn the
nozzle to the stop.
• To remove the nozzle, turn it back until the arrows on the
nozzle and adapter are pointing towards one another and
pull it out.
• The fl oor pad (L) is attached to the cleaning head with
Velcro straps. Place it on the cleaning head and push it
fi rmly. After use, simply pull it off of the cleaning head.
• To clean carpets, place the carpet glider (O) fl at on the
fl oor and place the cleaning head with the fl oor pad in the
carpet glider.
EN
14.02.2018 14:06:23 14.02.2018 14:06:23