Charging Up The Battery; Cleaning And Storage - Cleanmaxx BY-908 Mode D'emploi

EN

Charging Up the Battery

PLEASE NOTE!
■ Only ever charge up the battery with a matching USB cable (C
connector to A connector).
■ It is essential that you charge up the battery fully before
you fi rst use the device in order to achieve the maximum
charging capacity. If the battery is fully discharged during use,
it must be fully charged up again before it is next used.
A USB mains adapter is also required to charge up the
device. This is not supplied with the device.
1. Connect the USB A connector of the USB cable (6) to a suitable
USB mains adapter.
2. Connect the USB C connector to the connecting socket (7) on
the device.
3. Connect the USB mains adapter to a properly installed, easily
accessible plug socket. The operating lamp (2) lights up red.
The battery is being charged.
4. When the operating lamp lights up green, the battery is fully
charged. First disconnect the USB mains adapter from the
mains power and then disconnect the USB cable from the
mains adapter and the device.
The device cannot be switched on while it is charging.
Use
1. Place the dirt pad (5) under the stain.
2. Apply a little water and detergent to the stain.
3. Pull off the cap (4).
4. Hold down the On / Off switch (1). The operating lamp (2) lights
up green.
5. Glide the sonic head (3) over the stain several times.
6. Let go of the On / Off switch to switch off the device. The operat-
ing lamp goes out.
7. Wash the item of clothing in the usual way.

Cleaning and Storage

PLEASE NOTE!
■ Do not use any caustic or abrasive cleaning agents to clean the
device. These may damage the device.
■ No water or other liquids must be allowed to enter the device
during cleaning.
1. Make sure that the device is not connected to the mains power.
2. Wipe down the device and in particular the sonic head (3) with
a damp cloth. Do not use any cleaning agents.
3. Then dry with a cloth before the device is re-used or stored
away.
4. Keep the device and accessories out of the reach of children
and animals in a dry, frost-free place that is protected from the
sun.
To prevent a deep discharge of the battery, charge it up from
time to time if it is not used for a prolonged period.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
Customer Service / Importer:
*) Calls to German landlines are subject to your provider's charges.
All rights reserved.
Troubleshooting
If the device does not work properly, fi rst check whether you are able
to rectify the problem yourself. If the problem cannot be solved with
the steps that are listed, contact our customer service department.
Do not attempt to repair an electrical device yourself!
Problem Possible cause
The device The battery is empty.
does not start.
The USB mains adapter
is not plugged in the
plug socket correctly or
the USB connectors are
not plugged correctly in
The battery is
the connecting socket of
not charging
the device or the USB
up.
mains adapter.
The plug socket is
defective.
There is no mains volt-
age.
Technical Data
Model number:
Voltage supply:
Ultrasonic frequency:
Battery
Charge time:
Operating time:
Article number:
ID of operating instructions: Z 07924 M DS V1 0919
Disposal
Dispose of the packaging material in an environmentally
friendly manner so that it can be recycled.
The device with a built-in battery is governed by the
European Directive 2012/19/EU on waste electrical
and electronic equipment (WEEE). Do not dispose
of this device as normal domestic waste, but rather
in an environmentally friendly manner via an offi cially
approved waste disposal company.
✆
+49 38851 314650 *)
Operating Instructions
Solution
Charge up the bat-
tery.
Correct the fi t.
Try another plug
socket.
Check the fuse of the
mains connection.
BY-908
3.7 V (Li-ion battery, 800 mAh)
47 kHz
up to 1.5 hours
approx. 20 minutes
(with fully charged battery)
07924