Filling The Water Reservoir; Use - Cleanmaxx D260 Mode D'emploi

EN

Filling the Water Reservoir

PLEASE NOTE!
■ When the water reservoir is fi lled, the main unit must not be tilted, turned upside
down or laid or placed on its side. Water could escape!
1. Flip the stem with the handle (1) and the stem mount (6) on the main unit (11) up-
wards. It must be upright so that the device is deactivated and cannot be switched
on accidentally.

Use

Switch the device off after each surface has been cleaned as this will considera-
bly increase the operating time on each battery charge.
1. Tilt the stem with the handle (1) back a little in order to trigger the release mechanism
in the stem mount (6) and activate the device. The lamp (9) switches on and the bat-
tery status display (8) lights up.
2. Press the On / Off switch (13) on the handle to switch on the device. The two cleaning
feet (10) start to vibrate.
3. Guide the device over the surface which is to be cleaned or polished.
4. If necessary, press the spray trigger (2) on the handle to make the fl oor damp with the
aid of the spray nozzle (9).
5. To switch off the device, press the On / Off switch on the handle again.
6. Tilt the stem with the handle upwards in order to trigger the release mechanism in
the stem mount and activate the device. You must feel the stem engage. The lamp
switches off and the battery status display goes out.
7. Clean the cleaning cloths after use (see the "Cleaning and Storage" chapter).
18
3. Attach one cleaning cloth in each case to a cleaning
foot (10) using the Velcro fastener.
4. To detach the cleaning cloths, simply pull them off the
cleaning feet.
2. Open the water reservoir cap (12) on the main unit.
3. Fill the water reservoir with water using the measuring cup
(max. 100 ml).
4. Securely close the water reservoir cap again.