Removing The Docking Station - Stihl RMI 632 Manuel D'utilisation

● Activate the highest safety level
( 11.16)
● RMI 632 C, RMI 632 PC:
Activate ECO energy mode (
● Activate the disabling device (
● Disconnect the power supply unit plug
from the mains
● Carefully clean all external parts of the
robotic mower and the docking station.
Cover the docking station with a suitable
bucket, fasten the bucket.
● Store the robotic mower on its wheels in
a dry, closed and dust-free room. Make
sure that the machine is kept out of the
reach of children.
● Always store the robotic mower in good
operational condition.
● Keep all screws tightly fastened,
replace danger signs and warnings on
the machine that have become illegible,
check the entire machine for wear and
damage. Replace all worn or damaged
parts.
● Any machine faults must be completely
remedied prior to storage.
0478 131 9942 C - EN
Never place or store objects on the
robotic mower.
The temperature in the storage
11.11)
room should not fall below 5°C.
5.2)
Resuming operation of the robotic
mower following storage for a long period:
The date and time may need to be
corrected following storage for a
long period. Appropriate selection
windows are displayed during initial
operation. If the selection windows
are not automatically displayed,
check the date and time in the
"Settings" menu and correct if
necessary. (
● Prepare the mowing area:
Remove foreign objects and cut high
grass short using a conventional lawn
mower.
● Uncover the docking station and
connect the power supply unit to the
mains supply.
● Charge the battery (
● Check the mowing plan and change as
necessary. (
● Switch on automatic mowing (
● RMI 632 C, RMI 632 PC:
If necessary, activate Standard energy
mode ( 11.11) and switch on GPS
protection. (

16.9 Removing the docking station

The docking station can also be removed
if the robotic mower is to be stored for
long periods (e.g.winter break).
● Preparing the robotic mower for storage
for a long period (
11.11)
15.8)
11.6)
11.5)
5.10)
16.8)
● Disconnect the power supply unit plug
from the mains
● Remove the docking station cover and
open the panel ( 9.2)
1 Fold open the left clamping lever (1).
2 Remove the left wire end (2) from the
terminal block.
Close the clamping lever (1) again.
3 Fold open the right clamping lever (3).
4 Remove the right wire end (4) from the
terminal block.
Close the clamping lever (3) again.
● Close the panel ( 9.2)
● Guide the left and right wire ends out of
the docking station separately from
each other
● Fit the docking station cover ( 9.2)
159