Sony UP-50 Mode D'emploi page 88

Setting Up the Printer (Continued)
88
Installation and Adjustment
4
Adjust the printout color.
1 Select the item to be adjusted by pressing the F or f button.
2 Perform the adjustment by pressing the G or g button.
The RED, GREEN and BLUE color component and contrast settings are
divided into 15 steps, from –7 to +7, indicated by a value and graph. The
center of the graph (0) corresponds to the standard color.
SHARPNESS is divided into 15 steps from 1 to 15, indicated by a value and
graph. A setting of step 8 corresponds to the standard sharpness.
For INTERPOL. (interpolation), select either ON or OFF depending on the
type of image
When adjusting the RED/GREEN/BLUE (color intensity)
Menu Adjustment
item When you want to
CYN-RED Make the image reddish.
Make the image cyan.
MAG-GRN Make the image magenta
(pink).
Make the image greenish.
YEL-BLU Make the image yellowish.
Make the image bluish.
COLOR ADJUST COLOR : 200
/ COL / LAY / PRN / IN / OUT /
LOAD COLOR : 1 / 2 / 3
CYN – RED : 0
MAG – GRN : 0
YEL – BLU : 0
DARK : 0
LIGHT : 0
SHARPNESS : 8
INTERPOL. : OFF / ON
SAVE COLOR : 1 / 2 / 3 [EXEC]
Q1 A 1
Button to be
pressed
g button
G button
g button
G button
g button
G button
CYN – RED
TEMP
MAG –GRN
Y E L B L U
S
Adjust the color intensity for each adjustment item.
Adjustment direction
on the menu
Toward RED
Toward CYN (cyan)
Toward MAG
(magenta)
Toward GRN (green)
Toward YEL (yellow)
Toward BLU (blue)
: 0
: 0
: 0