Before Transporting The Printer; Cleaning; Cleaning The Cabinet - Sony UP-50 Mode D'emploi

Location

Before Transporting the Printer

Cleaning

Cleaning the cabinet

To prevent internal heat built-up, leave enough room around the printer for air to
circulate through the vents on the left hand side of the cabinet.
Before transporting the printer, use the following procedure to remove the
supplied accessories and then put them back into their original packing.
Transporting the printer with the supplied accessories still installed may cause
malfunctioning.
1
Remove the ink ribbon cartridge and the paper tray.
2
Secure the internal thermal head, as follows:
1 Use the POWER switch to turn on the printer.
2 Press the MENU, G and g buttons of the cursor keys on the sub panel
simultaneously.
3 Use the POWER switch to turn off the printer.
The thermal head is now secured.
To release the thermal head
Turn on the printer again. The thermal head moves so that you can now install the
ink ribbon cartridge again.
Note
Be sure to turn off the power of the printer before starting cleaning.
Clean the cabinet, panel and controls with a soft dry cloth, or a soft cloth lightly
moistened with a mild detergent solution. Do not use any type of solvent, such as
alcohol or benzine, which may damage the finish.
121
Others