Verathon GlideScope Go Manuel D'utilisation Et De Maintenance page 266

4. Allow the battery to charge until the indicator LED is solid green.
5. Remove the monitor from the cradle, and then press the Power button on the
monitor.
Note: Do not attach a blade or baton at this time.
6. In the upper right corner of the monitor screen, verify that the installed software
version is 1.3 or higher. If not, contact Verathon Customer Care for a software
update.
PROCEDURE 3. CONFIGURE USER SETTINGS
The User Settings Tool is a Java‑based tool and is available on the USB flash drive.
Note: The User Settings Tool requires Java Runtime Environment version 1.8 (Java Platform
SE 8) or later. The USB flash drive contains 32‑bit and 64‑bit Java updaters. If you must
update Java on the computer where you intend to run the User Settings Tool, use the
installer that matches the bit depth (number of bits) of the Java software you currently have
installed. This may be different from the bit depth of your operating system.
1. Connect the USB flash drive to a USB port on a computer.
2. Navigate to the USB flash drive, and then open the User Settings Tool.
Configure the settings as needed, and then click Save.
3.
4. In the Save As dialog box, navigate to the USB flash drive, and then click Save.
5. Ensure the monitor is powered off, and then insert the USB flash drive into the
micro‑USB port on the monitor.
6. On the monitor, press the Power button. The monitor powers on and the settings
automatically update. The settings file is then automatically deleted to help prevent
accidentally overwriting the date and time settings.
260
0900‑4788 REV‑10