Setting Up The System - Verathon GlideScope Go Manuel D'utilisation Et De Maintenance

SETTING UP THE SYSTEM

PROCEDURE 1. PERFORM INITIAL INSPECTION
1. Verify that you have received the appropriate components for your system by
referring to the packing list included with the system.
2. Inspect the components for damage.
3. If any of the components are missing or damaged, notify the carrier and Verathon
Customer Care or your local representative.
PROCEDURE 2. CHARGE THE BATTERY
Please read the
following task.
For more about the battery and charging conditions, see
1. Connect the power adapter to a hospital‑grade power outlet.
2. Ensure the micro‑USB port on the monitor is dry.
3. If charging directly from the power adapter, connect it to the micro‑USB port on
the monitor.
If charging with the charging cradle, connect the power adapter to the micro‑USB
port on the cradle, and then place the monitor in the cradle.
See the following table for a list of indicator LED status descriptions.
Table 13.
LED Status
Solid green
Solid orange
Solid red
Blinking red
Off
* Using an unapproved power adapter may not charge the battery correctly. Please replace the unapproved
power adapter with the power adapter provided with the system.
Hoiatused ja ettevaatusabinõud
Indicator LED Status Descriptions
Battery is fully charged.
Battery is charging with an approved or equivalent power adapter.
Battery is charging with an unapproved power adapter.
Error. There is a problem with the battery or charging circuit.
Not charging.
section before performing the
Battery Specifications
Description
on page 269.
*
259
0900‑4788 REV‑10