Maintenance & Safety - Verathon GlideScope Go Manuel D'utilisation Et De Maintenance

MAINTENANCE & SAFETY
Please read the
PERIODIC INSPECTIONS
In addition to the user performing routine inspections before and after every use, periodic
inspections should be performed to ensure safe and effective operation. It is recommended
that you perform a full visual inspection of all components at least every three months. The
inspector should check the system for the following:
• External damage to the equipment
• Damage to the power adapter
• Damage to the connectors
Report any suspected defects to Verathon Customer Care or your local representative.
BATTERY
After 300 charge and discharge cycles, the battery capacity is approximately 80% of the
initial capacity. Under normal operating conditions, this may happen at around 3 years. For
more information about the battery, see
The battery is not user‑replaceable. Do not attempt to replace the battery. Any attempts to
replace the battery by unauthorized service technicians may cause serious harm to the user
and will void the warranty. For more information, contact Verathon Customer Care or your
local representative.
SYSTEM SOFTWARE
This manual documents the most current version of the software. If your monitor does not
function as described in this manual, or to determine if your software should be updated,
contact Verathon Customer Care. Do not perform any software upgrades from third‑party
vendors or attempt to modify the existing software. Doing so may damage the monitor
and void the warranty.
DEVICE REPAIR
The system components are not user‑serviceable. Verathon does not make available any
type of circuit diagrams, component parts lists, descriptions, or other information that
would be required for repairing the device and related accessories. All service must be
performed by a qualified technician. If you have any questions, contact Verathon Customer
Care or your local Verathon representative.
DEVICE DISPOSAL
The system and related accessories may contain batteries and other environmentally
hazardous materials. When the instrument has reached the end of its useful service life, it
must be disposed of in accordance with WEEE requirements. Coordinate disposal through
your Verathon Service Center, or alternatively, follow your local protocols for hazardous
waste disposal.
Warnings & Cautions section before performing maintenance.
Battery Specifications on page 19.
0900‑4788 REV‑10
17