Transport And Storage; Maintenance; Malfunctions; Technical Specifications - Tunturi Cardio Fit R30 Mode D'emploi

start measuring at the same heart rate level as
precisely as possible.
To switch back to the main display by pressing
4.
RESET. The console will also automatically
switch to the main display one minute after the
completion of the measurement.

TRANSPORT AND STORAGE

Move the device according to the following
instruction, because lifting the cycle incorrectly
may strain your back or cause other risk of
accidents:
Stand behind the device and grip the rail with one
hand and the seat with the other. Tilt the device
so that is rests on the transportation wheels. Move
the device by wheeling it on transportation wheels.
Lower the device onto floor while holding on to
the rail and the seat,all the time remaining behind
the device.
Transport the equipment with caution over uneven
surfaces, for example over a step. The equipment
should never be transported upstairs using the
wheels over the steps, instead it must be carried.
We recommend that you use a protective base
when transporting the equipment.
To prevent malfunctioning of the cycle, store in
a dry place with as little temperature variation as
possible, protected from dust.

MAINTENANCE

•
The R30 requires very little maintenance.
Check, however, from time to time that all screws
and nuts are tight.
•
Clean the cycle with a damp cloth. Do not use
solvents.
•
Never remove the protective covers.
•
Clean the inner surfaces of the rail if necessary
so that the seat moves as smoothly and quietly as
possible. If necessary, you may improve the seat
movement by adding paraffin to the surface of the
rails.
CHANGING BATTERIES
The console gives a warning signal before the
change of batteries is due. Remove the battery
compartment cover from the back side of the meter
and remove old batteries. Place new batteries in
the holder (note the direction of the batteries) and
reattach the cover.
To minimize the strain on the resistance
mechanism, we recommend that the resistance
adjustment knob is set to position 1 after every
training session.
8

MALFUNCTIONS

Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also the
nature of the problem, conditions of use and
purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.

TECHNICAL SPECIFICATIONS

Length ......................................... 200 cm
Width .......................................... 48 cm
Height .......................................... 56 cm
Weight .......................................... 46 kg
The R30 meets EN precision and safety standards
(EN-957).
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
The instructions must be followed carefully
NOTE!
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifications not expressly approved
by Tunturi Oy Ltd will void the user's authority to
operate the equipment!
We wish you many enjoyable trainings with
your new Tunturi training partner!