Installation Of Wall-Mounted Master Flux - Tecno-gaz Master Flux Plus Mode D'emploi

ENGLISH
6.2

Installation of wall-mounted master flux

(FIGURE A7-A8)
Attach the Master Flux SUPPORT to the wall (13) using 4 Ø14 mm M8 wall dowels.
Attach the Master Flux PLATE to the wall (12) using 4 Ø 8(mm) wall dowels.
Screw the pin (11) onto the base of the flowmeter box.
Slot the pin into the end of the support (13).
Lock the pin to the support using the relative threaded knob (13A).
Screw the nut on the N
(RIGHT threading).
Connect the nut on the O
(LEFT threading).
Connect the free ends of the tubes to the wall outlets (press the couplings and turn to
lock the coupling to the outlet).
12
200 mm
180 mm
Figure 7
O tube (9) onto the N
2
tube (10) to the O
2
O flowmeter box supply nipple
2
flowmeter box supply nipple
2
115 mm
90 mm