Urmet 2Voice 1083/40 Mode D'emploi page 5

The wiring junction box must be wall mounted with the provided double-sided adhesive tape or with screws
and screws anchors.
VIDEO MODULE INSTALLATION
The video module, provided with the bracket Ref. 1732/91, can be installed on the right of the
switchboard.
1 – Fix the video module bracket to the switchboard bracket with two little brackets and 4 screws which
must be placed in the specifi c seats.
2 – Extract the switchboard fi xing hook.
3 – Remove the switchboard from the bracket.
4 – Connect the video module cable to the switchboard bracket.
5 – Make a hole in the switchboard plastic side.
6 – Place again the switchboard body and fi x it with the locking hook.
1
3
Disconnect the fl at
cable, noting the
connector direction.
8
2
4
DS1083-017
5
6
§
If the video module must be placed near a table top mounted switchboard, before starting operations
described above, install the suitable support and the 2 feet provided with the video module bracket.
DS1083-017
Connect the fl at cable,
observing the connector
insertion direction.
9