Urmet 2Voice 1083/40 Mode D'emploi page 4

INSTALLATION
TABLE TOP INSTALLATION
By default, the switchboard is confi gured for table top installation, with the specifi c support which ensures
the best inclination.
The wiring junction box must be wall mounted with the provided double-sided adhesive tape or with screws
and screws anchors.
WALL INSTALLATION
1 – Remove the table support and the two feet from the switchboard bracket.
2 – Extract the switchboard fi xing hook.
3 – Remove the switchboard from the bracket.
4 – Remove the door phone cover of the switchboard.
5 – Unscrew the base of the switchboard door phone from the bracket.
6 – Fix the bracket to the wall with screws and screw anchors.
7 – Mount again the door phone base by screwing it to the bracket.
8 – Put again the door phone cover.
9 – Put again the door phone body in its seat and fi x it with the locking hook.
1
3
6
2
Disconnect the fl at cable, noting
the connector direction.
4
6
8
Connect the fl at
cable, observing the
connector insertion
direction.
DS1083-017 DS1083-017
5
7
9
7