Urmet 2Voice 1083/40 Mode D'emploi page 13

FUNCTION BUTTONS
In the switchboard there are 6 programmable function buttons (11). The following codes can be associated
to each function button:
• a special code to activate the special decoder Ref. 1083/80
• a code used to divert a call to a telephone managed by the interface Ref. 1083/67
For each of the 6 function buttons the setting screen is the following:
F1 BUTTON
(0=NO,1=SPEC,2=TEL)
To confi gure this parameter use the buttons
• if the value 0 is selected, no special function will be assigned to the button,
• if the value 1 is selected, the function of special code sending will be associated to the button and the
display shows the following screen:
F1 BUTTON
TYPE SPECIAL CODE
(0=NO,1=SPEC,2=TEL)
Enter the special code to be associated to the button (1÷255) and press the button
next function button;
• if the value 2 is selected, the call diversion function will be associated to the button and the display shows
the following screen:
F4 BUTTON
TYPE DIVERTING CODE
(0=NO,1=SPEC,2=TEL)
Enter the physical code which is the diversion destination and press the button
function button. This function is available only for buttons F4, F5, F6.
The same procedure can be used to program the remaining 5 function buttons.
24
0
and (18):
1
(7) to confi gure the
2
(7) to confi gure the next
NAME MANAGEMENT
In this screen the user can enter, change or delete a user from the device.
To enter a name, select 1 on the numeric keypad (12).
•
With the alphanumeric keypad enter the physical code followed by the button
one is not requested if the device is programmed to operate with physical codes) followed by the button
(7) and then enter the user name using the numeric keypad as it was the keypad of a mobile.
Button
1
2
3
4
5
6
7
8
9
Symbols can be selected with the buttons
When all data have been entered, press the button
When names are being entered, the following confi gurations are not accepted by the system:
– 2 users with the same name
– In logical code mode, enter 2 users with different physical code and the same logical code.
• To change a name, select 2 on the numeric keypad (12):
DS1083-017 DS1083-017
NAMES
(1=INS,2=MOD,3=DEL)
(0=CLEAR ALL)
NAME INS.
PHY:00012 LOG:1000
ROSSI
PAOLO
1 touch 2 touches 3 touches
Blank 1
A B C
D E F
G H I
J K L
M N O
P Q R
T U V
W X Y
and (18).
(7) to confi rm.
NAME MOD.
0001/0083
PHY:00012 LOG:1000
ROSSI
PAOLO
(7), the logical code (this
4 touches 5 touches
2
3
4
5
6
S 7
8
Z 9
25