Control Board Description - afx light Shooter-2 Manuel D'utilisation

CONTROL BOARD DESCRIPTION

Press "MENU" to select different functions. Use Up and Down to change value of the selected function and press
Enter to validate your set
Menu :
o DMX address : Set DMX address
o Channel mode : Choose between 17CH and 21CH DMX operating mode
o Show mode : Choose stand alone operating mode( Sound or auto modes )
o Blackout : To enable blackout mode ( Yes or No )
o Sound state : To enable sound mode ( Yes or No )
o Sound sense : To adjust mic sensitivity in sound mode ( from 0 ( Low sens ) to 100 ( High sens ))
o Inverse Pan : Select pan function : Normal or reverse pan
o Invert TILT : Select Tilt function : Normal or invert tilt
o Back light : To switch off the back light of LCD display after several seconds ( On or Off )
o Lamp off : To switch the lamp on or off
o Auto test : To check the good operating of all parts of the device
o Temp ° : to show the temperature state of the lamp ( from -20° to 200°C )
o Fixture time : To show the using time of the device
o Firmware version : To show the firmware version of the device
o Factory default : To load the factory setups ( Yes to download or No to cancel )
o System reset : To restart all parts of the device to their starting position
© Copyright LOTRONIC 2015 SHOOTER-2R Page 6