Publicité
Handle starter assembly (Illustration D + L1 )
–
The safety control bracket (1) on the upper handle (2) must be folded down before the starter cable can be suspended.
–
Pull out the starter cable (3) slowly and fit in the starter handle mount (4) with a twist motion.
Assemble the collecting sack and hang it onto the mower (Illustration Q1 + R1 + S1 )
–
Press the lateral retaining clip (2) of the chute (1) onto the collecting bag frame Q1 .
–
From below, hang the bar (3) of the crossbar into the chute.
–
Then press the lower retaining clips (4) onto the crossbar of the collecting bag frame.
–
First insert the grass bag frame with the clip forward into the grass bag. Align the upper seams of the bag with the clip.
–
Press the retaining profiles of the collecting sack onto the bars of the collecting sack frame R1 .
–
Open the ejection flap of the mower upwards.
–
Pick up the collecting sack by the carrying strap, place the chute (1) at the collecting sack opening into the ejection flap
and hang it in the mower casing with its two side hooks upwards S1 .
–
Attach ejection flap to collector.
Adjusting the cutting height (Illustration I )
The cutting height is adjusted behing the motor.
–
Press the grey push button with your thumb and lift or lower the mower handle to bring it into the required position.
–
Release the push button: the lever now engages in the required cutting height.
–
The marking on the left of the housing shows the adjusted cutting height.
IMPORTANT
Mowing at the lowest cutting height should only be carried out on level and plane lawns!
Please observe that the lower cutting height settings may only be used for optimal conditions. If you select cutting
height that is too low, the turf can be damaged and under certain circumstances it can even be destroyed.
Besides the cutting height, also the moving speed influences the cutting pattern and collection result. Adapt the
cutting height and moving speed to the grass height to be cut.
8 BEFORE USING THE LAWNMOWER FOR THE FIRST TIME
Check that all connections and the spark plug connector are fitted firmly. Tighten the screws if necessary! In particular make
sure that the cutter bar is fitted correctly (see Chapter "Maintenance of the blade").
The blade attachment screw must always be tightened by an authorised workshop. If the blade attachment screw is too tight
or too loose, the blade clutch and blade can be damaged or become detached, which can cause severe injury.
Make sure that all safety devices are fitted properly and are not damaged.
Filling with oil (Illustration Y1 )
IMPORTANT
Avoid damage! Engine is delivered without oil. You must add oil before running the engine.
Before starting the engine for the first time, use a funnel to fill motor oil (quantity and quality see technical data) having
unscrewed the dipstick in this opening first.
–
Set the mower on level ground.
–
Slowly fill oil through the filler neck. Do not overfill.
–
Check oil level
Ölmess-Stab entfernen. Use a clean cloth to wipe off the dipstick, then insert it again and screw tightly. Then pull the
dipstick out again and read off the oil level. The oil must be at the full mark at the top (arrow). Replenish oil if necessary.
The oil level must not be higher than the full mark, however.
Insert the oil dipstick again and tighten.
–
After initial filling, remove the "NO OIL" sign from the top of the engine.
See table for explanation of symbols page 3
See table for explanation of symbols page 3
See table for explanation of symbols page 3
9
Safety instruction!
GB
Safety instruction!
Safety instruction!
Publicité
