Publicité
•
Make sure that the spark plug connector is firmly seated! Touching is only a risk if the spark plug connector is not
installed correctly.
•
For reasons of safety, always replace worn or damaged parts.
Protective gloves must be worn at all times during maintenance and cleaning work.
Maintenance and cleaning work must only be carried out if the engine has been turned off and the spark plug
connector has been removed.
•
Never remove the spark plug connector when the motor is running! Risk: Electric shock.
•
If the tank has to be emptied, this should be done in the open, and with a cold engine. Take care to ensure that no fuel
is spilt.
For warranty and safety reasons, original replacement parts must be used at all times.
6
DESCRIPTION OF COMPONENTS
1
Safety control bar for motor brake
2
Setting handle for adjusting cutting height (carrying handle at the back) with push-button
3
Engine cover
4
Tank cap
5
Primer pump
6
Air filter
7
Cutting height display
8
Carrying handle, front
9
Spark plug
10 Exhaust protection grid
11 Oil refill neck with dipstick
12 Starter cable handle
13 Ejector flap
GB
7
PREPARATION
The following parts are included in the packaging for assembly of the mower:
•
Mower with preassembled handle
•
Collecting bag, collecting bag frame, chute
•
Tool bag with the following contents:
–
Operator's manual with Declaration of Conformity
–
Warranty conditions and Warranty card
–
Various fixing parts.
In the unlikely event of a missing part, please contact your dealer.
Opening out the handle (Illustration A1 + E1 + B1 + O4 )
–
Pull the folded-up Z-shaped guide spar apart and upward A1 .
–
When upper and lower handle are aligned tighten the two wing-nuts by hand E1 .
–
Push both ends of the bottom part of the handle with the toothed plastic adapters backwards until they click into the
toothed recess on the mower housing B1 .
In this way, three different handle heights can be set.
–
Tighten the two wing-nuts on both sides by hand B1 .
–
Insert the cable on the left hand side into the cable guide. This is to prevent the cable from being trapped when folding
the handle E1 .
–
Attach the Bowden cable to the bottom section of the guide spar with the aid of cable ties from the tool bag O4 .
CAUTION
When you activate the bar height adjustment, when loosening the wing nuts B1 used to secure the bar bottom to
the housing (only loosen sufficiently to ensure that the bar can be moved freely) and snapping the toothed plastic
adaptations from the cut-out on the housing, it is possible that unintentional upsetting of the bar may occur. In
addition, this may result in crushed points between the bar bottom and the housing. This may result in a risk of
injury!
8
Publicité
