Publicité
ELITE SII
Place the two electrodes on the area that must be treated, at a distance of
•
about 10-20 cm and fix them with the elastic band.
Gradually increase the intensity until the patient feels a slight tingling.
•
Once the program is finished, turn the device off, and disconnect the
•
electrodes. Clean the sponges and bands following the instructions on the
drug leaflet. If not indicated, it is however recommended to wash the sponges
and elastic bands very well, with plenty of hot water and soap, so that the next
time there are no traces of the drug.
Indications for the treatment with incontinence programs
The use of muscle stimulation programs referred to the treatment of urinary
incontinence can be used exclusively for the treatment of urge, stress and mixed
incontinence.
These three programs are indicated for the reinforcement of the pelvic floor, that
often cause incontinence. The program must be chosen after a diagnostic of the
type of incontinence (urge, stress and mixed). Urological applications entail the use
of vaginal or anal probes for the specific intended use, which must be covered by
the CE MDD certification, in compliance with the directive 93/42/CEE. Such probes
must be bipolar and equipped with a 2 mm female connector for 2 mm male
cables. Such probes are available in stores with the following reference codes:
REF G1188 Single-patient vaginal probe
REF G0757 Single-patient anal probe.
Warnings
Since these applications have a medical intended use, they must be carried out
upon previous medical authorization.
Use
• To use the probes correctly, follow the instructions provided by the manufacturer
or the physician.
• Then connect the stimulation cable to the probe: the connector of the
stimulation cable with the + symbol must be connected to the red connector of
the probe. The - symbol must be connected to the black connector of the
probe.
REV 5 DEL 16.10.2023
GENESY SII
DUO TENS
69
Publicité
