Télécharger Imprimer la page

Husqvarna TC 220TD Manuel D'utilisation page 37

Publicité

10. Put the chocks in front of and behind the rear
wheels.
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If
you keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
mixing ratios given by the manufacturer. Run the engine
for a minimum of 10 minutes after you add the stabilizer
until it flows into the carburetor.
WARNING:
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames, sparks,
or pilot lights in for example boilers, hot
water tanks and clothes dryers.
WARNING:
other flammable materials from the product
TC 220TD
Dimensions
Width, excl. cutting deck, mm
Width, incl. cutting deck, mm
Height, mm
Length, excl. grass catcher, mm
Length, incl. grass catcher, mm
2311 - 002 - 27.09.2024
Do not keep the product
Remove grass, leaves and
Technical data
to decrease the risk of fire. Let the product
become cool before you put it in storage.
Clean the product, refer to
page 22 . Repair paint damages to prevent corrosion.
Examine the product for worn or damaged parts and
tighten loose screws and nuts.
Remove the battery. Clean it, charge it, and keep it
cool during storage.
Change the engine oil, and discard the waste oil.
Empty the fuel tank. Start the engine and let it
operate until there is no remaining fuel in the
carburetor.
CAUTION:
tank and carburetor if a stabilizer has
been added.
Close the fuel shut-off valve.
Remove the spark plugs and put approximately a
tablespoon of engine oil into each cylinder. Manually
turn the engine shaft to apply the oil and put the
plugs back on.
Lubricate all grease nipples, joints and axles.
Keep the product in a clean and dry area and put a
cover on it for more protection.
A cover for protection of your product during storage
or transportation is available at your dealer.
Disposal
Chemicals can be dangerous and must not be
discarded on the ground. Always discard used
chemicals at a service center or an applicable
disposal location.
When the product is worn out, send it to the dealer
or to an applicable recycling location.
Oil, oil filters, fuel and the battery can have negative
effects on the environment. Obey the local recycling
requirements and applicable regulations.
Do not discard the battery as domestic waste.
Send the battery to a Husqvarna service agent or
discard it at a disposal location for used batteries.
971
1140
1124
2029
2714
To clean the product on
Do not empty the fuel
37

Publicité

loading