Télécharger Imprimer la page

Husqvarna TC 220TD Manuel D'utilisation page 35

Publicité

Problem
There is vibration in the product.
The cutting result is unsatisfactory.
2311 - 002 - 27.09.2024
Cause
The blades are loose.
The blades are incorrectly installed.
The blades are not balanced.
The engine is loose.
The belt pulleys are skew or loose.
The blades are blunt.
The blades are incorrectly installed.
The grass is long or wet.
The cutting deck is not parallel.
There is grass blockage in the cutting
deck.
There is grass blockage in the center
chute.
The air holes in the cutting deck are
clogged.
There is dirt around the blade pul-
leys.
The tire pressure is different on the
right and left sides.
The product is operated at a too high
speed.
The engine speed is too low.
The cutting deck belt slips.
The cutting deck belt is worn or dam-
aged.
Action
Tighten the blades. Refer to
place the blades on page 31 .
Make sure that the blades are instal-
To replace the
led correctly. Refer to
blades on page 31 .
Examine the blades for wear and
To examine the
damage. Refer to
blades on page 31 .
Speak to your Husqvarna servicing
dealer.
Speak to your Husqvarna servicing
dealer.
Examine the blades for wear and
To examine the
damage. Refer to
blades on page 31 .
Make sure that the blades are instal-
To replace the
led correctly. Refer to
blades on page 31 .
To get a good cutting result
Refer to
on page 19 .
Adjust the parallelism of the cutting
To adjust the parallel-
deck. Refer to
ism of the cutting deck on page 30 .
Clean the cutting deck. Refer to
clean the product on page 22 .
Remove the grass blockage in the
center chute.
Clean the cutting deck. Refer to
clean the product on page 22 .
Clean the cutting deck. Refer to
clean the product on page 22 .
Make sure that the tire pressure is
correct in all 4 tires. Refer to
pressure on page 28 .
To get a good cutting result
Refer to
on page 19 .
To get a good cutting result
Refer to
on page 19 .
Speak to your Husqvarna servicing
dealer.
Replace the cutting deck belt. Refer
To replace the cutting deck belt
to
on page 32 or To replace the cutting
deck belt on page 32 .
To re-
To
To
To
Tire
35

Publicité

loading