Publicité
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To replace the battery
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Fold the seat forward.
2. Remove the 4 screws and the storage compartment.
3. Remove the terminal cover on the black battery
cable.
4. Remove the screw, the washer, the nut, and the
black battery cable from the negative (-) terminal on
the battery.
5. Remove the terminal cover on the red battery cable.
28
Risk of electrical shock and
6. Remove the screw, the nut, and the red battery
cable from the positive (+) terminal on the battery.
7. Carefully remove the battery from the product.
8. Put a new battery in position.
9. Attach the red battery cable to the positive (+)
terminal on the battery and install the nut and the
screw.
10. Install the terminal cover on the red battery cable.
11. Attach the black battery cable to the negative (-)
terminal on the battery and install the nut, the screw
and the terminal cover.
12. Install the battery cover and the attach the strap.
13. Install the storage compartment and the 4 screws.
Tire pressure
Make sure that the tire pressure is correct in all 4 tires.
Technical data on page 37 .
Refer to
Cutting deck
To remove and install the cutting deck
1. Disengage the cutting deck and stop the engine.
2. Put the cutting deck in the lowest position.
3. Remove the 3 screws and the left belt cover.
2311 - 002 - 27.09.2024
Publicité
