Publicité
WARNING:
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury. Keep
body parts away.
9. Move the cutting height lever to the highest position.
10. Push down the lower chute and remove the cutting
deck from the product.
11. Install the cutting deck in the opposite sequence.
CAUTION:
belt is installed correctly and does not
get compressed when you install the
cutting deck.
a) Make sure that the lower chute is in the correct
position when you install the cutting deck.
To remove and install the center chute
1. Disengage the cutting deck and stop the engine.
2. Remove the grass catcher.
30
The mechanism
Make sure that the drive
3. Remove the 2 clips.
4. Pull out the center chute.
5. Install the center chute in the opposite sequence.
To adjust the parallelism of the cutting deck
To do a side-to-side adjustment of the cutting deck
If the cutting height is different between the right and left
side, the cutting height can be adjusted.
1. Make sure that the tire pressure is correct in all 4
Tire pressure on page 28 .
tires. Refer to
2. Park the product on a level surface.
3. Put the cutting deck in the highest position.
4. Measure the distance (X) from the bottom edge of
the cutting deck to the ground on the left and right
side. The distance must be the same on the 2 sides.
X
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
5. Loosen the locknuts on the cutting height stays.
X
The blades on the
2311 - 002 - 27.09.2024
Publicité
