Publicité
11. Sit in the seat and start the engine. Refer to
the product on page 16 .
12. Engage the cutting deck and let it operate until the
cutting deck is dry.
To clean the air intake of the engine
WARNING:
intake has rotating parts which can cause
injury to your fingers.
Note:
The illustration shows one type of engine.
The engine in your product can be different, but the
procedure is the same.
1. Open the engine cover.
2. Make sure that the air intake on the engine is not
blocked.
3. Remove grass and dirt with a brush.
To clean the cooling fan on the transmission
WARNING:
cooling fan rotates and can cause injury to
your fingers.
1. Remove the center chute. Refer to
install the center chute on page 30 .
2311 - 002 - 27.09.2024
To start
Stop the engine. The air
Stop the engine. The
To remove and
2. Clean the cooling fan on the transmission with
compressed air.
To remove and install the engine cover
1. Open the engine cover.
2. Disconnect the headlight wire connector (A).
3. Tilt the engine cover forward and lift it to remove it
from the product.
4. Install the engine cover in the opposite sequence.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Apply the parking brake. Refer to
release the parking brake on page 17 .
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Push the parking brake pedal again to release the
parking brake.
To replace the fuel filter
Note:
The illustration shows one type of fuel filter.
The fuel filter on your product can be different, but the
procedure is the same.
A
To apply and
23
Publicité
