Publicité
4. Remove the 3 screws and the right belt cover.
5. Remove the spring (A) from the spring holder (B) to
decrease the tension of the cutting deck belt.
B
Note:
The model has 2 cutting deck belts and 2
springs.
6. Remove the cutting deck belt from the engine pulley.
7. Do the steps that follow to disconnect the front link.
a) Remove the clip (C) and the washer (D).
b) Disconnect the front link (E) from the bracket (F)
on the cutting deck.
2311 - 002 - 27.09.2024
A
D
C
F
E
c) Put the front link in the front link holder.
8. Do the steps that follow to disconnect the 2 rear
links. There is one rear link on the left side and one
rear link on the right side of the product.
WARNING:
heavy. Use a crowbar or equivalent
below the cutting deck to hold the weight
of the cutting deck when you disconnect
the 2 rear links.
a) Remove the clip (E) and the washer (F) from the
front end of the left rear link.
E
F
b) Disconnect the cutting deck from the left rear
link.
c) Pull and hold the cutting height lever in the
lowest position with one hand. Remove the clip
and the washer from the front of the right rear
link.
WARNING:
cutting height lever. The mechanism
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury if you
do not pull and hold the cutting
height lever.
d) Disconnect the cutting deck from the right rear
link.
e) Carefully release the cutting height lever.
The cutting deck is
Do not release the
29
Publicité
