Publicité
Note: Stay still during the measurement process and do not talk to
prevent the measurement result from being falsified.
460437_2401_V3.0_silv_Blutdruckmessgeraet_Content_OS.indd 57
460437_2401_V3.0_silv_Blutdruckmessgeraet_Content_OS.indd 57
Ensure correct fit before the measurement is taken using the index
markings described below.
Place the cuff
on a bare upper arm (fig. D). The blood flow of
1
the arm should not be constricted by clothing etc. which is too tight.
Position the cuff
1
up from the elbow and over the artery. The cuff tubing
towards the middle of the palm.
Place the free end of the cuff
the arm and close the hook and loop fastener (Fig. E). The cuff
should not be too tight. Check that two fingers can still fit beneath
the cuff
(Fig. F).
1
This cuff is suitable for you if, after putting it on, the index mark on
the outside of the cuff (▼) is within the OK range on the cuff (Fig. G).
Now insert the cuff tubing
nection
(Fig. H).
4
If the measurement is being taken using the right upper arm, the
air tube should be over the inner side of your elbow. Ensure that
you do not press on the air tube with your arm.
Adopting the correct posture
You can carry out the measurement while sitting or lying down.
Always ensure that the cuff
(Fig. I-K).
Sit comfortably for the blood pressure measurement. Use your
chair's back and arm rests. Do not cross your legs.
Put your feet flat on the ground.
To prevent falsifying the measurement result, it is important that
you stay still and do not talk.
on the upper arm so the lower edge is 2–3 cm
closely, but not too tightly, around
1
with the cuff plug
2
is at the same level as the heart
1
points
2
1
into the con-
3
GB/IE
57
29.05.24 10:51
29.05.24 10:51
Publicité
