BRAVILOR BONAMAT B5 Mode D'emploi page 93

7.3.8 Lengthening water
delivery time by setting
pauses
The default time required for making a full
container of coffee can be lengthened by setting
pauses. This is, for example, necessary when
very finely ground coffee or very soft water is
used. Then some more time is needed for the
water to go through the coffee filter, otherwise it
will overflow. The capacity is reduced. This is
indicated in %.
− Default setting to 100%, so no pauses.
− The setting range is between 100% and 50%,
to be set in 5% steps. After the setting, the
machine calculates the pause schedule itself.
It can, however, be set to when the first
pause should come.
− The setting must be determined by
experience by making coffee.
− The minimum amount that can be set for the
first pause is the volume of the filter cone
+25%.
Model Contents filter cone
B5
2 litres
B10
4 litres
B20
8 litres
B40
15 liter
Table 10 Minimum amount first charge
%
G
H
I
J
K L M
Fig. 35 Pause time 100%
D Press selection key (N.)⇑ until fig.35 appears
on the display.
D Press programming key (G.).
− The position beside the programming key
starts flashing.
D Press selection key (M.)⇓ or (N.)⇑ to select the
desired programme.
− The enter symbol ↵ appears on the display.
ECopyright Bravilor Bonamat B.V.
D Press confirmation key (L.) to confirm the
D Press programming key (I.).
TIP
− This can only be done when the percentage
D Press selection key (M.)⇓ or (N.)⇑ to select the
D Press confirmation key (L.) to confirm the
D Press selection key (N.)⇑ to go to the next
7.3.9
When the hot water supply through the spray head
has stopped, it will take a while until the filter pan
also stops dripping. The time required for this
varies with different coffee brands and/or grinds.
Therefore this dripping−on time can be changed.
− The default setting is on 120 seconds.
− The setting range is from 0 − 600 seconds in
Minimum amount first
charge
G
2,5 litres
5,0 litres
H
10,0 litres
20,0 liter
I
J
Fig. 36 Dripping−on time
The dripping−on time can be set as follows:
D Press selection key (N.)⇑ until fig.36 appears
D Press programming key (G.).
N
D Press selection key (M.)⇓ or (N.)⇑ to select the
D Press confirmation key (L.).
D Press selection key (N.)⇑ to go to the next
adjustment.
is not set to 100%.
desired amount of the first charge.
− The enter symbol ↵ appears on the display.
adjustment.
setting or press stop key (K.) to exit the
programming menu.
Setting dripping−on time
10 seconds steps.
K L M
on the display.
− The value beside the selection key starts
flashing.
desired number of seconds.
− The enter symbol ↵ appears on the display.
− The desired number of seconds has been
set now.
setting or press stop key (K.) to exit the
programming menu.
N
29
version 1.0