BRAVILOR BONAMAT B5 Mode D'emploi page 71

3.2 Installation
CAUTION!
− Do not overlook the risk of freezing. Never
place the machine in rooms in which the
temperature can drop below 0°C.
− Never install the machine in front of entrances,
exits or passageways intended for emergency
services.
D Place the machine on a flat, sufficiently solid
surface close to a water connection and an
earthed electrical power outlet. Leave sufficient
space at the back and front of the machine for
maintenance and repair purposes.
3.2.1 Connection to the water
and electrical system
D Connect the machine to a readily accessible
manually operated tap, so that the water
supply can easily be turned off.
WARNING
n Power supply voltages vary from one country
to another. Ensure that the machine is suitable
for connecting to the local power supply.
Details on the required supply voltage and
frequency can be found on the identification
plate.
D Connect the machine to the electrical supply in
such a way that the power can easily be
disconnected.
D Ensure that the machine is correctly earthed.
D Never connect the machine to a power supply
where heavy loads resulting from switching on
other machines may cause variations in voltage.
3.2.2 Initial use
TIP
− With initial use the machine makes use of the
default factory settings. These settings can, if
desired, later be changed by properly
trained authorised users (§ 7.3).
− With initial use the coffee−making system is
exclusively flushed with water; no coffee is
made.
ECopyright Bravilor Bonamat B.V.
3.2.2.1 Flushing the coffee−making
system
D Place the filter unit (P.) on the coffee container
(U.).
D Turn the spray head (C.) above the hole in the
cover (Q.) of the filter unit (P.).
D Switch the ON/OFF switch (E.) on.
− The indicator lamp in the switch lights up.
The default options appear in the display
(fig. 5 ).
D Push the selection key for amount 2 (H.).
− A signal sounds. The coffee−making
process is started. The selected amount
flashes in the display.
As soon as the hot water supply through the
spray head has stopped, the filter pan in the
display starts flashing. This means that the
dripping−on time has started. (Only when the
dripping−on time is set). The dripping−on time is
standard set to 2 minutes. After the dripping−on
time has terminated, a signal sounds (3 short
beeps) indicating that the coffee−making process
has finished.
D Tap the water through the coffee tap (X.).
D Turn the spray head above the filter unit of the
other container.
D Repeat the above steps for the other coffee
container.
After that the coffee−making system is ready for
use (chapter 4.)
G
H
I
J
M
K L
Fig. 5 Display with the default options
N
7
version 1.0