Publicité
Cold start
• Make sure that the appliance is refueled.
• Disconnect all power consumers from the appliance.
• Measure the oil level before every start, see section Cleaning, care and maintenance
on page 26.
• Check that the spark plug connector and the air filter are intact and firmly seated.
The appliance is delivered without oil. However, there are oil residues in the motor.
Before operating, be sure to fill up with oil according to the instructions!
Switch on
Risk of equipment damage and environmental damage. Cable connections
may come loose during operation. Check all visible cable connections for
tightness. Check the fuel system for leaks before every start!
• Open the fuel tap. See also Fig. 13. (Handle on the tap points downwards)
• Move the red motor switch to the "ON" position. (Fig. 1 1)
This section describes how to start generators without E-Start. Generators with E-Start
do not have an engine switch. Instead, the generator is started by turning the ignition
key to the start position. (Fig. 12)
If the power generator with electric start is to be started using a pull-wire starter, the
ignition key is moved to the center position and the pull-wire handle is pulled.
• Other steps must be applied in the same way.
Figure 1 1: Motor switch
EN
V. 1.2
Figure 12: E-starter
23
Publicité
