Mounting The Bar And Chain (Quick Chain Tensioner) - Stihl MS 170 Notice D'emploi

9 7
7
8
: Fit the guide bar over the studs (7) –
cutting edges on top of bar must
point to right – and engage the
peg of the tensioner slide in locating
hole (8) –- place the chain over
sprocket (9) at the same time.
: Now turn tensioning screw (10)
clockwise until there is very little
chain sag on the underside of the
bar –- and the drive link tangs are
located in the bar groove.
: Refit the sprocket cover –
and screw on the nuts only finger-
tight.
: Go to "Tensioning the Saw Chain".
MS 170, MS 180, MS 180 C
Mounting the Bar and Chain
(Quick Chain Tensioner)
1
10
t = a : 2
You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see "Specifications"):
The chain pitch (1) must match the pitch
of the sprocket and the guide bar (for
Rollomatic). The drive link gauge (2)
must match the bar groove width (3).
The pitch is marked on the chain
sprocket and guide bar in inches
(e.g. 3/8 or .325). The groove width
is marked on the guide bar in
millimeters (e.g. 1.6).
If non-matching components of the
wrong pitch or drive link gauge are
run together on the same machine
they may be damaged beyond
repair after a short period of
operation.
2
a
3
4
6
: Pull out the hinged handle (4) so
that it snaps into position.
: Turn the wingnut (5) counterclock-
wise until it hangs loose in the
sprocket cover (6).
: Remove the sprocket cover.
: Remove the tensioning gear (7)
and turn it over.
English
5
7
27