Ergostart; Safety Precautions And Working Techniques - Stihl MS 170 Notice D'emploi

ErgoStart

Chainsaws equipped with ErgoStart*
can be started with less effort at a lower
cranking speed.
Observe the following instructions:
: Keep children well away from the
machine – even small children could
start the saw.
: Hold the saw firmly by the front
handle during the entire starting
procedure.
: To help prevent the engine starting
unintentionally when the saw is not
in use, move the Master Control to
the stop position and engage the
chain brake.
Protect the machine from
unauthorized use (e.g. children).
See also chapter on "Starting / Stopping
the Engine".
* Special option
MS 170, MS 180, MS 180 C
Safety Precautions and
Working Techniques
Because a chainsaw is a
high-speed, fast-cutting
power tool, special safety
precautions must be
observed to reduce the
risk of personal injury.
It is important that you
read, fully understand and
observe the following
safety precautions and
warnings. Read the
instruction manual and
the safety instructions periodically.
Careless or improper use may cause
serious or fatal injury.
!
Warning!
Reactive forces, including kickback, can
be dangerous. Pay special attention to
the section on reactive forces.
Have your STIHL dealer show you how
to operate your power tool. All safety
precautions that are generally observed
when working with an axe or a hand saw
also apply to the operation of chainsaws.
Observe all applicable federal, state and
local safety regulations, standards and
ordinances.
!
Warning!
Do not lend or rent your power tool
without the instruction manual. Be sure
that anyone using it understands the
information contained in this manual.
!
Warning!
The use of this machine may be
hazardous.The saw chain has many
sharp cutters. If the cutters contact your
flesh, they will cut you, even if the chain
is not moving. At full throttle, the chain
speed can reach 30 m/s.
Use your chainsaw only for cutting
wooden objects. It must not be used for
any other purposes, since such misuse
may result in an accident or damage to
the machine.
!
Warning!
Minors should never be allowed to use
this power tool. Bystanders, especially
children, and animals should not be
allowed in the area where it is in use.
!
Warning!
To reduce the risk of injury to bystanders
and damage to property, never let your
power tool run unattended. When it is
not in use (e.g. during a work break),
shut it off and make sure that
unauthorized persons do not use it.
English
3