Stihl MS 170 Notice D'emploi page 39

English
STOP
0
5
3
4
When engine begins to fire:
: Move Master Control lever (3) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (4) –
the Master Control lever (4) will
move to the "Run" position # (5)
and the engine settles down to idling
speed.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine and chain brake might
otherwise be damaged.
38
: Pull the hand guard back toward
the front handle:=
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake
before accelerating engine. High
revs with the chain brake engaged
(chain locked) will quickly damage
the engine and chain drive (clutch,
chain brake).
: Observe safety precautions.
: Always check operation of chain
lubrication before starting work.
To shut down the engine:
: Move Master Control lever to $
At very low outside temperatures:
Allow the engine to warm up
As soon as the engine runs:
: Blip the throttle trigger to disengage
it from the starting throttle position.
The Master Control lever will move
to the normal run position – engine
settles down to idling speed.
: Disengage the chain brake:
Pull hand guard back toward front
handle as shown in illustration.
: Open throttle partly – warm up
engine for short period.
MS 170, MS 180, MS 180 C