Publicité
4.4
USING STEAM (Manual
steam wand)
CAUTION
RISK OF BURNS OR SCALDING
While using the steam nozzle, you must
pay attention to not place your hands
beneath it or touch just after it has
been used.
To use the steam function, pull or push
the relevant lever, as shown in the figure.
By pulling it completely the lever will
hold a position of maximum delivery; by
pushing it, the lever will automatically
give way.
The two steam nozzles are articulated to
guarantee their easy use.
NOTE: The use of the steam wand must
always be preceded (done before)
the cleaning out of the condensa-
tion for at least 2 seconds.
52
4.5
MAKING CAPPUCCINO
To obtain the typical cappuccino foam,
immerse the nozzle all the way into a
container 1/3 full of milk (preferably
cone-shaped). Turn on the steam. Before
the milk starts to boil, pull the nozzle
slightly up and lightly move it vertically
across the surface of the milk. When you
have completed the procedure, clean the
nozzle carefully with a soft cloth.
4.6
HOT WATER SELECTION
Fig. 12
RISK OF BURNS OR SCALDING
While using the hot water nozzle, pay
careful attention not to place your
hands beneath it or touch it just after it
has been used.
This nozzle delivers hot water to make
tea or herb teas.
Place a suitable container under the hot
water nozzle. Press the hot water select
button once; the light
on.
The hot water wand will deliver water for
the amount of time equivalent to the set
value (see PROGRAMMING section and
the DOSE PROGRAMMING section) or
press the button again to stop pouring.
NOTE: Hot water can be delivered at the
NOTE: The use of the hot water wand
Fig. 13
CAUTION
will switch
same time as coffee.
must always be preceded by the
purge of the hydraulic circuit for at
least 2 seconds.
Publicité
