Publicité
unless supervised or given instruc-
tions.
At the end of installation, the device
is switched on and taken to rated
operating conditions, leaving it in a
state in which it is "ready for opera-
tion".
The device is then switched off and
the whole hydraulic circuit is bled
of the first lot of water in order to
remove any initial impurities.
The device is then refilled and taken
to rated operating conditions.
After reaching the "ready for opera-
tion" condition, the following dis-
pensing operations are carried out:
• 100% of the coffee circuit through
the coffee dispenser (for more
than one dispenser, this is divided
equally);
• 100% of the hot water circuit
through the water dispenser (for
more than one dispenser, this is
divided equally);
• opening of each steam outlet for 1
minute.
At the end of installation, it is good
practice to draw up a report of the
operations.
The maximum and minimum stor-
age temperatures must fall within a
range of [+5, +50]°C.
The operating temperature must be
within the range of [+5, +35]°C.
The coffee machine must not be left
switched on without supervision, i. e.
without the presence of an operator.
Simonelli Group is not responsible
for any damage caused by malfunc-
tion of the machine, in case this
38
machine is left on without the pres-
ence of the operator.
When the machine is left unattend-
ed for a long period, close the water
inlet tap.
CAUTION
RISK OF ELECTRIC SHOCK
Basic rules must be observed when
using any electric appliance.
In particular:
• do not touch the appliance when
hands or feet are wet;
• do not use the appliance when
barefoot;
• never use extension cords in
rooms used as wash or shower
rooms;
• do not pull the supply cord out of
the socket to disconnect it from
the mains;
• do not leave the appliance
exposed to atmospheric agents
(rain, sun, etc..);
• do not let the appliance be used
by children, unauthorised staff or
staff who have not read and fully
understood the contents of this
handbook.
During installation, the mains
power system needs to be equipped
with a disconnector switch to cut
off each phase.
Before carrying out any mainte-
nance operation, the authorised ser-
vice engineer will switch off the
machine and open the disconnector.
For all cleaning operations comply
exclusively with the instructions
given in this booklet.
If the appliance breaks down or
fails to work properly, switch it off.
Any intervention is strictly forbid-
den.
Repairs should only be made by the
manufacturer or authorized vice
centres.
Only original spare parts must be
used.
Failure to observe the above, could
make the appliance unsafe.
For installation, the qualified elec-
trician must fit an omnipolar switch
in accordance with the safety regu-
lations in force and with 3 (0,12) or
more mm (in) between contacts.
To avoid dangerous overheating,
make sure the supply cord is fully
uncoiled.
Do not obstruct the extraction and/
or dissipator grids, especially of the
cup warmer.
The user must not replace the appli-
ance supply cord. If the cord is dam-
aged, switch off the appliance and
have a qualified technician change
the cord.
Single-phase appliances with cur-
rent above 15 A and three-phase
appliances sold without plugs are
directly wired to the mains power
Publicité
