Publicité
Prior to connecting the machine to the
electrical mains, assess that the voltage
shown on the machine's data plate cor-
responds with that of the mains.
If it does not, carry out the connections
on the basis of the available electrical
line, as follows:
• for 380V / 3 phases voltage + Neutral:
• for 230V / monophase voltage:
KEY
1 Black
4 Blue
2 Grey
5 Yellow-green
3 Brown
3.
ADJUSTMENTS TO BE MADE BY A QUALIFIED
TECHNICIAN ONLY
3.1
HOT WATER ECONOMISER
ADJUSTMENT
NOTE: this operation can be carried out
while the machine is turned on.
All models
water mixer, which serves to adjust the
temperature of the water leaving the
wand and to optimise system perfor-
mance.
To set the hot water economy device, use
a screwdriver on the screw in the top part
of the machine, as shown in the figure.
Fig. 7
• Turn it CLOCKWISE / ANTICLOCKWISE
to REDUCE / INCREASE the tempera-
ture of the hot water;
Fig. 8
3.2
The electronic control unit has a lithium
battery to power the clock; the battery
has an autonomy of about three years,
after which it will need to be replaced.
are fitted with a hot
In case of an extended period of machine
stoppage, the clock can be stopped:
Fig. 9
Replacement of the lithium battery
must be carried out EXCLUSIVELY by
Qualified Technician.
Simonelli Group cannot be held liable
for any damage to people or things due
to non observance of the safety pre-
scriptions described in this booklet.
REPLACING THE CLOCK
BATTERY
• with the machine off the display will
read:
CLOCK DISABLED
OFF
• hold the ON/OFF key down
sec. to release the clock.
WARNING
for 5
49
Publicité
