Publicité
4.
USE
Before starting to use the appliance, the
operator must be sure to have read and
understood the safety prescriptions con-
tained in this booklet.
NOTE: At the start of the daily activity
and anyway in case there are
pauses longer than 8 hours, one
must proceed to make happen the
100% change of the water con-
tained in the circuits using the
specific nozzles.
4.1
COMMISSIONING
PROCEDURE OR AFTER
BOILER MAINTENANCE
When commissioning the machine for
the first time or after carrying mainte-
nance switch ON the machine using the
main switch positioned lower down and
on the right and proceed as follows:
1) If the message "OFF – CLOCK
DISENABLED" appears on the display
proceed as follows in step three.
2) If the display reads "OFF" press the
ON/OFF
key until it reads "OFF –
CLOCK DISABLED" and then proceed
as described in step 3.
3) Switch on the machine using the ON/
OFF
key and automatically after the
machine has switched on, some water
will be poured from the groups for about
45 seconds to make sure that the coffee
boiler tanks have been properly filled.
This cycle cannot and must not be
interrupted.
If this cycle is interrupted due to a power
outage or if the machine is accidentally
switched off from the main switch, the
next time the machine is switched on,
the cycle will be started again for
approximately 45 seconds more.
50
NOTE: At the end of the installation, the
qualified technician must provide
the total replacement of the water
contained in the boiler for at least
three times before using effective-
ly the machine.
4.2
SWITCHING THE MACHINE
ON/OFF
SWITCH ON: plug the machine into the
power socket and press
the switch "A" so it is in
position "I"; the machine
will switch on.
A
WARNING
If the self-diagnostics report anoma-
lies or failures, the operator MUST NOT
intervene.
Please
contact
Assistance Centre.
• The lit display will show the firmware
version for about 1 second:
Release firmware 0.03
• The display, which is not illuminated,
will read:
NOTE: The machine is not operational,
since the main switch only powers
the electronic card.
WARNING
For electronic card maintenance, turn
the machine off by means of the exter-
nal main switch or disconnect the plug.
Fig. 10
MANUAL SWITCHING ON/OFF
Automatic On/Off NOT PROGRAMMED
NOTE: make sure that the general switch
is always on the position "I".
the
SWITCH ON: press the ON/OFF button
until the light switches on
and the buzzer makes a
beep sound.
The control unit will start
up an auto diagnosis cycle
to check the functions, all
the selection keys will light
up.
OFF
for about 2 seconds
Publicité
