Scheppach 5906147902 Traduction Des Instructions D'origine page 32

- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
The compressor does
not start
The compressor
starts but there is no
pressure
The compressor
starts, pressure is
shown on the pres-
sure gauge, but the
tools do not start
32 | GB
Possible cause
Mains voltage is not available
Mains voltage is too low
Outside temperature is too low
Motor is overheated
The safety valve leaks
The seals are damaged.
Drain screw for condensate
leaking.
Hose connection leaking.
A quick coupling has a leak
Insufficient pressure set on the
pressure regulator
www.scheppach.com
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.
Remedy
Check the cable, mains plug, fuse and socket
Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Do not operate at outside temperatures below
+5°C.
Allow the motor to cool down. If necessary, reme-
dy the cause of the overheating.
Replace the safety valve
Replace the seal, have defective seals replaced at
a specialist workshop.
Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
Check compressed air hose and tool, replace if
necessary.
Check quick coupling, replace if necessary.
Increase the set pressure with the pressure
regulator.